XYZ Printing ds Vinci Color Quick Manual page 6

Unpacking
8
Remove the cable tie and foam in front and back of the front door.
10
Place the top cover down with the
guide tube going through the hole in
the top.
12
Confirm the rubber magnet is well placed on the print bed.
11
Insert the other end of the guide tube into the feed module and
secure it tightly.
9
Insert the guide tube through the top
cover, and then insert one end into
the printing module.
Note
There is a sheet of PC film to
rubber magnet with a double
sided adhesive, this PC film is
replaceable, please replace it
when it's dirty or broken.
P5