User Operating Instructions - Triton T80Z Installation And Operating Instructions Manual

SECTION
10
check list
Fig.19
Power selector
High
COOLER
Temperature
control
Start/Stop
button

USER OPERATING INSTRUCTIONS

Cold
Economy
HOTTER
OPERATING THE SHOwER -
Make sure the commissioning procedure
has been carried out.
To start the shower
• Press the Start/Stop button and water will flow.
To stop the shower
• Press the Start/Stop button and water will
cease to flow.
• After stopping the unit MUST be isolated via
the 45amp isolating switch.
If restarting immediately after stopping,
be aware that a slug of hot water will be
expelled for the first few seconds.
To use the power selector
The power selector has three positions - COLD,
ECONOMY and HIGH.
Cold setting
- single blue line.
• Cold: the cold setting does not provide any
heat from the heater can to the incoming
water.
Economy setting -
• Economy: uses only one of the elements
within the heater can.
NOTE: if the stated flow rate required for the unit
cannot be met due to low water pressure, it will
be necessary to operate the unit on this setting
during the warmer months because of flow rate
limitations entering the unit.
High Setting
- double red lines.
• High: uses both of the elements within the
heater can.
IMPORTANT: it will take a few seconds for the
temperature to stabilise once changes have been
made.
16
(fig.19)
WARNING
single red line.