User Operating Instructions - Triton ASPIRANTE Installation And Operating Instructions Manual

Electric shower

Hide thumbs Also See for ASPIRANTE:

Installation and operating instructions manual (32 pages)

Table Of Contents

Table of Contents

OPERATING THE SHOWER -

• When the electricity supply to the shower is

switched on at the isolating switch, the red

"power" indicator will light under button A.

To start the shower

NOTE: the shower starts as a default on the High

heat setting if the Start/Stop button is used.

Button A, B, C or D may be pressed to start the

shower.

• Press A (Start/Stop) the shower starts on the

High setting automatically.

• Press B (Cold water) the shower will start on

the Cold setting.

• Press C (Economy heat) the shower will start

on the Economy setting.

• Press D (High heat) the shower will start on

the High setting.

To stop the shower

• The shower can be stopped by pressing

the start/stop button. When pressed, the

phased shutdown will begin and water will

cease to flow after a few seconds. When

the start/stop button is pressed water will

continue to flow in order to remove heated

water inside the unit (see phased shutdown

process, P17).

• Water will cease to flow after a few seconds.

• After phased shutdown the unit MUST be

isolated via the 45amp-isolating switch.

Cold water setting - blue indicator on

• Cold: The shower will set to Cold. The cold

setting does not provide any heat from the

heater can to the incoming water.

Economy heat setting - blue indicator on

• Economy: The shower will set to Economy,

using only one of the elements within the

heater can.

High heat setting - blue indicator on

• High: The shower will set to Maximum, using

both of the elements within the heater can.

IMPORTANT: it will take a few seconds for the

temperature to stabilise once changes have been

made.