Table of Contents
Advertisement
OPERATING THE SHOWER -
• When the electricity supply to the shower
is switched on at the isolating switch, the
"power" indicator will light.
To start the shower
• Press the START/STOP button and water will
begin to flow.
NOTE: Default start up setting is the HIGH setting.
To stop the shower
• Press the START/STOP button and the
phased shutdown will begin. Water will cease
to flow after a few seconds.
To use the control buttons
• There are two control buttons –
HIGH/ECONOMY and COLD (fig.21).
• The upper button – red symbol is for
switching between the HIGH and ECONOMY
power setting.
• The HIGH setting allows the highest flow
achievable for your preferred temperature.
This setting should normally be regarded as
optimum shower performance throughout the
year.
• The ECONOMY setting uses less energy
when the ambient mains water temperature
is high during hot months.
• The HIGH/ECONOMY button alternates
between the two settings: press the button
once to select the ECONOMY setting, press
the button again to reselect HIGH.
• Temperature adjustment at this setting is via
the temperature control.
• The lower button – blue symbol is for COLD
water only. Adjusting the temperature control
at this setting will only increase or decrease
the flow of the water from the showerhead.
(It will not alter the water temperature.)
IMPORTANT: it will take a few seconds for the tem-
perature to stabilise once changes have been made.
NOTE: If the stated flow rate required for the unit
cannot be met due to low water pressure, it will
be necessary to operate the unit on the Economy
setting during the warmer months because of
flow rate limitations entering the unit.
USER OPERATING INSTRUCTIONS
(fig.18)
15
SECTION
10
check list
Fig.18
Advertisement
Table of Contents
