Launch X-631 Plus User Manual page 40

LAUNCH
6. When the data of camber and toe-in is valid,
the corresponding data will be displayed;
when invalid, "-----" will be displayed.
7. When the system uses two-probe rod working
mode, toe-in is of total toe-in, indicated by
"TT"; when the system uses four-probe rod
working mode, toe-in is of individual toe-in,
indicated by "T".
8. When X-631+ wheel aligner uses No PC
Mode, the displayed data units of camber and
toe-in are all in Degree/Minute mode.
9. X-631+ wheel aligner supports all functions of
X-631 wheel aligner. When the computer is
put into work, the probe rod will automatically
exit No PC Mode.
X-631/X-631+ Wheel Aligner
4-25
Operation Instructions