Additional Measurement; System Measurement - Launch X-631 Plus User Manual

LAUNCH
1. This interface provides only the functions of the test
and adjustment for front and rear toe-in and camber.
For other functions, please select them on the
interface of [Standard Measurement].
2. The default unit for toe-in on this interface is
centigrade. Only the vehicle model data is selected,
can the display unit for toe-in be in accordance with
the toe-in unit set on the interface of System
Management]-[System Setting].
3. Only the vehicle model data is selected, can the
measured values be saved in the interface of [Print
Report].
Special Note: During [Caster Swing], [Rear Axle
Measurement], [Front Axle Measurement] and [Quick
Measurement], if the sensor is blocked, it is
necessary to perform the settings for low-chassis
vehicle. The interface is as shown in Fig.4.34.
This setting can be automatically reset when
re-selecting the vehicle model or exiting the test system.
Caution: After the probe rod's position dropped, the level
adjustment should take the electronic level as the
standard.

Additional Measurement

This interface provides an operating platform for
special measurement, which can measure and display
left lateral offset, right lateral offset, axle offset, front
setback, rear setback, track width difference and
wheelbase difference, etc. The interface is as shown in
Fig.4.35.
Fig.4.35
X-631/X-631+ Wheel Aligner
4.34
Select Vehicle Model
[Select Vehicle Model]: Click this button to select the
parameters of standard vehicle model. If the parameter
values of wheelbase and front/rear track width are
contained in the standard database, each angle value
displayed on the screen will automatically be converted
into length value with the unit of mm.
Caution:
The system provides the dynamic measurement and
display for these special values, but the measurement
result will not be saved in the database.

System Measurement

On the main menu, please click the icon of [System
Measurement] to enter the measurement interface as
shown in Fig.4.36.
User information
The information of maintenance station is mainly used
to record the contact method of the maintenance
station and the information of the maintenance
technician. This kind of information can be imported to
report forms, which can make the information of
maintenance station be displayed on the report form
printed out, and is convenient for your data
management and tracing operation. The interface is as
shown in Fig.4.37.
[Setting]: After entering this interface, the information
box will be displayed with French gray back-ground, in
4-11
Operation Instructions
Fig.4.36
Fig.4.37