Launch X-631 Plus User Manual page 18

LAUNCH
interface as shown in Fig.4.6.
Operating procedures:
According to the prompts on the interface of [Vehicle
adjustment Help],
measurement for four suspensions by the way of
using the gradient meter, and then connect the
gradient meter to the computer host, the system will
confirm the standard data of current vehicle model
according to each level value measurement by the
gradient meter.
2. When some special vehicle models (such as
BMW 3 series) are selected, the screen will pop
up an interface of [Vehicle Counterweight] as
shown in Fig.4.7.
According to the requirements on the interface, put
the sandbags with appropriate weight on the vehicle
seats or in the baggage case, and fill the oil tank
according to the requirement. Please click [NEXT]
button to perform the next operation after finishing the
previous procedures.
3. When some special vehicle models (such as
BMW 3 series) are selected, the screen will pop
up an interface of [Height Measurement] as
shown in Fig.4.8. This interface provides an
operating platform for ride height measurement
system, in order to check if the ride height meets
the design requirements of OEM.
X-631/X-631+ Wheel Aligner
Fig.4.6
please perform the
Fig.4.7
Operating methods:
According to the prompts on the picture at the bottom of
the interface, measure left, right, front and rear ride
level
height values respectively to see if they are within the
standard range or not. If the height measurement
value(s) is (are) not within the standard range, please
check the vehicle status, and adjust the corresponding
components to keep 4 Height Measurement Values
within the standard range. Click [NEXT] after finished.
4. When some special vehicle models (such as
RENAULT MEGANE ) are selected, the screen
will pop up an interface of [Dependent
Suspension Measurement] as shown in Fig.4.9.
This interface provides an operating platform for
dependent suspension measurement system, in
order to confirm the standard data according to
the current status of the vehicle body.
Operating methods:
According to the prompts on the picture at the bottom
of the interface, measure left, right, front and rear ride
height values respectively, and input them into the
corresponding inputting boxes. Click [NEXT] after
finished.
Caution:
1). Testing conditions for ride height measurement
z
z
z
4-3
Operation Instructions
Fig.4.8
Fig.4.9
Specified tire pressure
Good and even tread pattern
Specified wheel bearing clearance