Launch X-631 Plus User Manual page 28

LAUNCH
Fig.4.41
[Modify]: This function is only applied to modifying the
user-defined information in the list. It cannot modify the
information imported from the standard data.
[Delete]: This function is only applied to deleting the
user-defined information in the list. It cannot delete the
information imported from the standard data.
Operating procedures:
Directly click manufacturer to select corresponding
vehicle model, in order to give the operator a
convenient view for the standard data of the vehicle
model.
Frequent Model
In order to speed up the information search, the system
provides the commonly used data management
function which can individually add the vehicle
information in the standard data into the commonly
used data. The interface is as shown in Fig.4.42.
Fig.4.42
[Added from the standard data]: Click this button, the
standard data window will be activated. Select the
required vehicle model from the standard data list. After
confirming, the information can be added from the
standard data to the commonly used data list.
[Delete]: Delete the items selected from the commonly
used data.
System Setting
System setting function is used to adjust the function
X-631/X-631+ Wheel Aligner
Added from the standard data
Delete
and display effect of software system. The interface is
as shown in Fig.4.43.
[Basic setting]: With this function the system can be
switched between Normal Version and Demo Version,
and between Special Version and Common Version.
[Normal version]: is the version directly applied in
actual testing operation; [Demo version]: this version
can, in stand-alone status, simulate the testing process
without external hardware equipments, it hasn't testing
ability, only used to demonstrate the testing process;
[Common version]: this version provides all-around
HELP information and operating demo animation to
fully help the testing personnel who contacts this
system for the first time; [Special version]: for
experienced operator, too much HELP information will,
on the contrary,
version provides the necessary HELP information only
to make the operator be working with more high
efficiency.
[Normal mode]: It is a default mode, and used in the
case of no direct sunlight or strong ground reflection
light.
[Strong light mode]: It is used when there is direct
sunlight or strong ground reflection light.
[Setting for run-out compensation]: the system provides
three types of run-out compensation: 1) 180-degree
compensation (turning for 2 times)
compensation (turning for 4 times) 3) Rolling run-out
compensation.
[Setting for kingpin steering operation]: the system
provides two types of kingpin measurement: 1)
Steering wheel turns by 20 degrees; 2) Steering wheel
turns by 10 degrees.
[Probe rod calibration setting]: you can select all CCD
sensors or end CCD sensor to calibrate
[Probe rod setting]: When one pair of front probe rods
or rear probe rods is faulty, you can use the normal pair
of probe rods to finish the part of the test items. For
example, all four probe rods are used in normal case.
When front probe rods are faulty, you can select "Use
rear probe rods" to tell the system only to use rear
probe rods to perform the test.
4-13
Operation Instructions
Fig.4.43
become encumbrance, so this
2) 90-degree