Launch X-631 Plus User Manual page 17

LAUNCH
[Navigation column]: To enter into the item you want
to test in spite of the default sequence.
[Commonly used data list]: The vehicle model in the
list can be directly selected to perform the next-step
operation. It is blank when firstly used. Only the
vehicle model data must be added into this list from
the standard database, can the list be used (See
[System Management] - [Commonly used data
management]).
[Selected from standard data]: If there is no the
vehicle model you want, you can directly search for
the vehicle model you want from the standard
database, and directly perform the next-step
operation This vehicle model is no longer saved in
the commonly used data list . If you want to add this
vehicle model into the commonly used data list, it
needs to be added from the interface of [System
Management] - [Standard Data Management]).
[Quick search]: The input box for quick search aiming
at the vehicle model is provided at the bottom of the
interface. Please input the first letter of the vehicle
model to perform the searching operation.
[Tire parameter]: When the unit of toe-in is used in
mm or In (The unit of toe-in can be set in [System
Management] – [System setting]), the diameter of the
present tire must be input.
[Low chassis measurement setting]: When test the
vehicle with the low chassis, please use this setting to
perform the measurement for the intelligent position-
dropping of the probe rod's end part, in order to solve
the problem of blocking the sensors when testing the
vehicle with the low chassis. This setting can be
automatically reset when re-selecting the vehicle
model or exiting the test system. Caution: After the
probe rod's position dropped, the level adjustment
should take the electronic level as the standard.
[Help]: To provide the description of operating method
and note.
Operating procedures:
Select the corresponding vehicle model item in
[Commonly used data list], then click [Next].
Note:
1. When the toe of the system uses linear measure,
it is required to enter the vehicle tire diameter at
the right bottom corner on this interface,
otherwise the system cannot enter the next
operating procedure
2. The form currently provided is the same form
with Commonly Used Data Management in the
System Management interface, in the same way,
X-631/X-631+ Wheel Aligner
4-2
you can click button to add the standard
data provided by the system into this form. If you
want to add user-defined data, you need to add it
from Standard Data Management interface of
System Management. The unit of Wheelbase,
Front wheelbase and Rear wheelbase is mm.
Special Measurement:
For different data of vehicle model, some special
measurement methods and operating procedures will
occur:
1. Aiming at some vehicle model of Benz, the
system provides the operations for measuring
the standard data with gradient meter. When the
data selected is of Benz vehicle, the system will
pop up a dialogue box as shown in Fig.4.4.
Fig.4.4
The interface for vehicle level measurement is
displayed in Fig.4.5.
Fig.4.5
Use gradient meter—the special measurement
instrument (optional) to get the level values of four
wheels, which are displayed in the editing boxes. Also,
the operator can take the level value scopes
displayed on the top of the editing boxes as the
reference, and manually input the corresponding level
values of four wheels.
[Vehicle Adjustment Help]: It provides the using
method of the gradient meter for Benz vehicle, the
operator can perform the vehicle test and adjustment
with the reference of the operating methods in Help
Operation Instructions
Vehicle
adjustment
Help