Configuration Main Menu; Configuring The Ip Address - Psion Teklogix 9150 User Manual

3.1 Configuration Main Menu

The 9150 Flash memory can be reconfigured remotely via the network using a
standard HTML Web Browser such as Netscape Navigator (version 4.05 or later) or
MS Internet Explorer (version 4.0 or later). The 9150 Configuration program allows
various configuration parameter settings to be changed, added or deleted.
Important: The 9150 must be warm rebooted after parameter changes are made ,
including configuring the IP address (see below), in order for the
changes to take effect. For details, see "Reboot Unit" on page 43.

3.2 Configuring The IP Address

Before the configuration menus can be accessed using your Web Browser, the 9150
must be assigned an IP address using a PC console connection. Virtually any PC
can be connected to the console port of the 9150, provided that the PC has a
terminal communication program such as the Windows "HyperTerminal" utility or
"Procomm Plus" for Windows. These programs emulate an ANSI terminal such as
VT220 or higher. Cable no. 19387 should be used to connect the PC to the 9150.
Make sure the communications settings on your PC are set to 8 bits, 1 stop, no
parity, and that the baud rate of the serial port matches that of the 9150 console port
(19,200 baud).
After the PC is attached and turned on, press the <RETURN> key several times until
the ">" prompt appears. The commands used to configure IP addresses are
described here.
If your system uses a bootp server to assign IP addresses, make sure that "bootp" is
enabled. Once enabled, and the 9150 is rebooted, you will be able to access the
9150 configuration menus through the Web Browser, using the IP address identified
in the server's bootp table. If you do not use a bootp server, make sure that "bootp"
is disabled and continue with the configuration commands to manually assign an
IP address.
Important: When your configuration is completed, the changes should be
saved to flash by entering the following command (commands are
case-sensitive):
>cfg commitCache
Chapter 3: 9150 Main Configuration

Configuration Main Menu

Teklogix 9150 Wireless Gateway User Manual
25