9010 / Tcp/Ip; Emulation Options - Psion Teklogix 9150 User Manual

Chapter 4: Base Station Configuration

9010 / TCP/IP

Emulation and Protocol
This parameter allows you to select the emulation and protocol to be used for the
connection to this host. As a base station, the 9150 can use either 9010/ TCP/IP or
9010/SERIAL, depending on the connection to the network controller or host.
Terminal Range
This parameter allows you to specify the range of terminals which will communi-
cate with this host. The left-hand textbox contains the lowest terminal number which
is allowed to communicate with the host; the right-hand textbox contains the highest
terminal number. Terminal numbers may range from 1 to 3840.

4.4.2 9010 / TCP/IP

4.4.2.1

Emulation Options

Refrain from sending On-line & Off-line messages
√
If this parameter is enabled ( ), the 9150 base station does not notify the host if
the status of a terminal changes between offline and online. If this parameter is
disabled, the 9150 does notify the host regarding any terminal status changes.
67
Teklogix 9150 Wireless Gateway User Manual