Base Stations - Psion Teklogix 9150 User Manual

Chapter 4: Base Station Configuration

Base Stations

4.5 Base Stations

These options and parameters allow you to configure the 9150 as a master base
station connected to up to 32 slave 9150 and 9140 base stations over an Ethernet or
Token Ring network. The master 9150 is connected to a 9400 or 9300 Network
Controller, or up to six hosts running TSDK (Teklogix Software Development Kit).
From the Base Stations option under Base Station Configuration (see Figure 4.2 on
page 48), entering "Configure" will open the "Configure New Base Station" page,
which will enable you to add a new slave base station to the system or change the
parameters on an existing slave base station.
Name
The name entered in this parameter is used as an alternate way of identifying the
IP address of a slave base station.
IP Address
This parameter provides the corresponding IP address for the slave base station.
The IP Address must be a unique value so that each slave base station can be iden-
tified on the network. The acceptable value ranges from 0.0.0.0 to 239.255.255.255.
The default value for the IP port is 16100.
Protocol
IAC/EOR (TCP/IP) is the default protocol for the Ethernet or Token Ring connection.
71
Teklogix 9150 Wireless Gateway User Manual