Chapter 2: Installation Requirements
Connecting To External Devices
Teklogix supplies the coaxial cable required to connect the 9150 to the antenna.
When determining the location of the antenna, the coverage requirements of the
antenna are considered in conjunction with the environmental requirements
of the 9150.
The coaxial cable must be routed and secured using wire anchors and/or coaxial nail
clips. A few extra inches of cable are required near the antenna and the 9150 to
make disconnection easier.
2.2 Connecting To External Devices
This section contains general guidelines for connecting the 9150 to external
devices such as network controllers, base stations, host computers, PCs and video
display terminals.
2.2.1 Ports
Figure 2.2 below shows the locations of the port and power connectors on the under-
side of the 9150. The port pinouts are described in Appendix A: "Port Pinouts And
Cable Diagrams".
10Base-T
10Base5
10Base2
AC Power Socket
On-Board Ethernet Adaptors
Console Port
10Base-T
10Base5
10Base2
Console
Lock
Unlock
Token Ring
Token Ring Adaptor
.igure 2.2 Base Of The 9150 (inset: optional Token Ring adaptor)
17
Teklogix 9150 Wireless Gateway User Manual