Table of Contents
Advertisement
2.19 VGA/LCD/LVDS interface connections
The PCM-9577's PCI SVGA interface can drive conventional CRT dis-
plays and is capable of driving a wide range of flat panel displays, includ-
ing passive LCD and active LCD displays. The board has three
connectors to support these displays: one for standard CRT VGA moni-
tors, one for flat panel displays, and one for LVDS type LCD panels.
2.19.1 CRT display connector (CN22)
CN22 is a 16-pin, dual-inline header used for conventional CRT displays.
A simple one-to-one adapter can be used to match CN22 to a standard 15-
pin D-SUB connector commonly used for VGA.
Pin assignments for CRT display connector CN22 are detailed in Appen-
dix C.
2.19.2 Flat panel display connector (CN23)
CN23 consists of a 40-pin connector which can support a 24-bit LCD
panel. It is Hirose's product no. DF13A-40DP-1.25 V
The PCM-9577 provides a bias control signal on CN23 that can be used
to control the LCD bias voltage. It is recommended that the LCD bias
voltage not be applied to the panel until the logic supply voltage (+5 V or
+3.3 V) and panel video signals are stable. Under normal operation, the
control signal (ENAVEE) is active high. When the PCM-9577's power is
applied, the control signal is low until just after the relevant flat panel sig-
nals are present. CN23 can connect up to 24 bit TFT LCD.
2.19.3 Extension flat panel connector (CN18)
CN18 consists of a 20-pin connector which is Hirose's product no.
DF13A-20DP-1.25V. The PCM-9577 supports a 36-bit LCD panel which
must be connected to both the CN23 (40-pin) and the CN18 (20-pin). The
pin assignments for both CN23and the CN18 can be found in Appendix C
2.19.4 LVDS LCD panel connector (CN15)
The PCM-9577 uses the VIA Twister chip that supports 2 channel (2 x
18 bit) LVDS LCD panel displays. Users can connect to either an 18-bit
or 36-bit LVDS LCD with CN15.
PCM-9577 User's Manual
20
- Quick Links:
- Connectors
- Jumpers
Hide quick links:
Advertisement
Table of Contents
