Set The Datalog Mode And Interval; Using The Secure Digital Memory (Sd) Card; Updating Software; Save Data And Event Logs With Sd Cards - Hach Polymetron 9500 User Manual

Set the datalog mode and interval

Datalog Setup is available if a calculation has been set up.
1. Push the menu key and select Polymetron 9500 SETUP>DATALOG SETUP.
Option
SET MODE
SET INTERVAL

Using the secure digital memory (SD) card

An SD card must be installed in the controller.
• The SD card can be used to update software and firmware and to download event and data logs. If
the SD card is installed while the controller is in the main menu, push the home key and then the
menu key to verify the option is visible. The SD icon will also be visible in the upper status bar of
the main measurement screen when a card is installed.
• Data log files on the SD card are available in XML and binary formats.
• DataCom is used to convert files from binary to CSV format. Refer to the DataCom manual for
more information on how to use the application. For a copy of the DataCom manual, software
updates or other downloadable resources, go to
http://www.hach.com

Updating software

Notes:
• The controller does not automatically transfer information to or from an SD card.
• When the SD card is put in multiple controllers, each controller has a separate set of folders in the
SD card memory. To make sure software updates are in the correct folder for the controller in use,
it is best to use a separate dedicated SD card for each controller.
1. Push the menu key and select SD CARD SETUP.
2. Select UPGRADE SOFTWARE and push the enter key.
Note: If the UPGRADE SOFTWARE option does not appear, perform the steps in
cards on page 40.
3. Select a device from the list and push the enter key. The list of options includes the controller and
all connected devices that have software placed in the appropriate folder on the SD card.
4. If more than one version of the upgrade software is available, select the version with the highest
number and push the enter key.
5. Push the enter key to begin the software transfer. The display will show "TRANSFERRING
FILES. PLEASE WAIT..." The percentage of completion appears in the bottom left corner of the
display. The upgrade cannot be halted once it has begun.
• When the transfer is successful, the display will show "TRANSFER COMPLETE" along with a
prompt to push enter to restart the controller or to push the back key and exit to the SD CARD
SETUP menu. Controller updates take effect when the controller is restarted. A restart is not
necessary for sensor updates.
• If the transfer is unsuccessful, the display will show "TRANSFER FAILED" and an error
message. Push the enter key to acknowledge the warning and exit out of the menu. Error
messages are different for each sensor. Refer to the applicable sensor manual.

Save data and event logs with SD cards

Notes:
• Data and event logs can be downloaded to an SD card and viewed with any device capable of
reading an SD card.
38 English
Description
Select an option (SNAP SHOT, AVERAGE, MAXIMUM, MINIMUM).
Select an interval from the list.
and search DataCom.
http://www.hach-lange.com or
Firmware updates with SD