Unpacking And Placing The Unit - M2TECH YOUNG MKIII User Manual

YOUNG M III
K
DIGITAL-TO-ANALOG CONVERTER AND PREAMPLIFIER
REVISION 1.0 – SEPTEMBER 2017

1. Unpacking and Placing the Unit

Lay the package on a table and open the external box by removing or cutting the adhesive
tape seal. Then extract the internal box and open it by lifting the front wing. The following
items are included:
 one YOUNG MKIII;
 one wall wart (AC-to-DC adapter);
 one USB A-B cable;
 two XLR-RCA high quality adaptors;
 one remote control;
 two AAA type batteries.
Should one or more item be missing, please contact your retail dealer.
Remove the YOUNG MKIII from the box and place it onto a stable base, far from heat
sources. Avoid full sunlight on the unit. Allow for ample room around the unit for venting.
The YOUNG MKIII is a high efficiency device; therefore it doesn't produce relevant heat
during its operation. Regardless, it's recommended to guarantee an adequate air flow
around the unit. Moreover, every time it will mainly be operated by remote control, it's
recommended to place it so as the remote control's infrared signals can easily reach its
front panel.
Avoid smoke, moisture, dirt and liquids from reaching the unit. Please note that any signs
of abuse will void warranty coverage.
Do not place the unit on thick carpets or inside a box or piece of furniture, not even close
to curtains.
7
M2Tech
www.m2tech.biz
Copyright © 2017, M2Tech Srl