Unpacking And Placing The Unit - M2TECH CROSBY User Manual

CROSBY
STEREO POWER AMPLIFIER
REVISION P A – SEPTEMBER 2017
R

1. Unpacking and Placing the Unit

Lay the box on a table and open it with a cutter or a knife, paying attention not to damage
the internal box. Extract the internal box and open it The following items are included in a
cardboard tray:
 one CROSBY;
 one power cord.
Should one or more item be missing, please contact your retail dealer.
Remove the CROSBY from the cardboard tray enclosure and place it onto a stable base, far
from heat sources. Avoid full sunlight on the unit. Allow for ample room around the unit for
venting.
The CROSBY is a power amplifier capable of delivering up to 400VA when operating at full
power in bridged mono mode with low impedance loads. Even if its efficiency is high,
therefore very low power is lost in heat, and even if its' not always driven at full power, the
unit can produce a relevant heat. Therefore, an adequate air flow is recommended.
Avoid smoke, moisture, dirt and liquids from reaching the unit. Please note that any signs
of abuse will void warranty coverage.
Do not place the unit on thick carpets or inside a box or piece of furniture, not even close
to curtains.
7
M2Tech
www.m2tech.biz
Copyright © 2017, M2Tech Srl