Balance: Balance Setting; Display Backlight: Setting The Display Backlight - M2TECH YOUNG MKIII User Manual

M2Tech
YOUNG M III
K
DIGITAL-TO-ANALOG CONVERTER AND PREAMPLIFIER
REVISION 1.0 – SEPTEMBER 2017
www.m2tech.biz
Once the desired menu item is displayed, it is possible to choose the desired value
amongst the allowed values rotating the encoder or using the "arrow left" and "arrow right"
keys on the remote control.
The new value can therefore be confirmed with a new short push of the encoder or by
pushing the "OK" key on the remote control.
If, at this point, the user changes his/her mind and wants to keep the current value, it's
possible to exit the menu by pressing the front panel's left button or by pushing the "ESC"
key on the remote control.
Following is a description of all menu items.

7.5.1. BALANCE: Balance Setting

The YOUNG MkIII allows for setting the balance (that is, the relative level between left and
right channel) within a +/-6dB range in 0.5dB steps. To set balance it is necessary to
access the first menu item.
SETUP
BALANCE
BALANCE BALANCE BALANCE
L <__-> R L <> R L <-_> R
Left channel is increased with regards to right channel by rotating the encoder counter
clockwise or by pushing the "arrow left" key on the remote control; right channel is
increased with regards to left channel by rotating the encoder clockwise or pushing the
"arrow right" key on the remote control.
To confirm or discard the newly chosen balance setting, proceed as described in
paragraph 7.5.
Changes to the balance can be heard in real-time while rotating the encoder knob or
pushing the "arrow left" and "arrow right" keys on the remote control. The new balance
setting is immediately stored in memory.

7.5.2. DISPLAY BACKLIGHT: Setting the Display Backlight

The YOUNG M III display backlight can be set to two different modes: AUTO OFF and
K
ALWAYS ON. In AUTO OFF mode, the display is always off except when a command is
executed. In ALWAYS ON mode, the display is always on.
To set the backlight mode it is necessary to access the first menu item or to use the "DIM"
key on the remote control.
Copyright © 2017, M2Tech Srl
21