Installing A Hot-Plug Sas Or Sata Drive - HP ProLiant DL560 Gen10 User Manual

15. Route and connect the cables depending on the types of drives installed and the server configuration.
For more information, see "Cabling on page 109."
To cable the drive cage to the HPE 12G SAS Expander, see "Installing the HPE 12G SAS Expander
Card on page 96."
16. If removed, do the following:
a. Install the air baffle (Installing the air baffle on page 43).
b. Install the processor mezzanine tray (Installing a processor mezzanine tray on page 87).
c. Install the 2P pass-through performance board (Installing a 2P pass-through performance board
on page 88).
17. Install the fan cage.
18. Install the access panel (Installing the access panel on page 41).
19. Install the server into the rack (Installing the server into the rack on page 34).
20. Connect each power cord to the server.
21. Connect each power cord to the power source.
22. Power up the server (Powering up the server on page 38).

Installing a hot-plug SAS or SATA drive

CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless all device bays are
populated with either a component or a blank.
Procedure
1. Remove the drive blank.
Installing a hot-plug SAS or SATA drive 63