CAUTION:
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
Determine the status of the drive from the hot-plug SAS drive LED combinations
1.
definitions" on page 14).
Back up all server data on the drive.
2.
Remove the drive.
3.
Installing a hot-plug SAS or SATA hard drive
The server can support five SAS or SATA hard drives in an SFF configuration.
To install the component:
Remove the drive blank.
1.
For proper cooling, do not operate the server without the access panel, baffles,
("Hot-plug drive LED
Hardware options installation 46