Table of Contents
Advertisement
Item
Description
3
NIC status LED
4
UID button/LED
1
When all four LEDs described in this table flash simultaneously, a power fault has occurred.
2
Facility power is not present, power cord is not attached, no power supplies are installed, power supply
failure has occurred, or the power button cable is disconnected.
3
If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the
system health status.
Systems Insight Display LEDs
The Systems Insight Display LEDs represent the system board layout. The display enables diagnosis with the
access panel installed.
Status
1
Solid green = Link to network
Flashing green (1 Hz/cycle per sec) = Network active
Off = No network activity
1
Solid blue = Activated
Flashing blue:
•
1 Hz/cycle per sec = Remote management or
firmware upgrade in progress
•
4 Hz/cycle per sec = iLO manual reboot sequence
initiated
•
8 Hz/cycle per sec = iLO manual reboot sequence
in progress
Off = Deactivated
Systems Insight Display LEDs
11
Advertisement
Table of Contents
