HP ProLiant DL560 Gen10 User Manual page 86

d. Using a T-30 Torx screwdriver, tighten the nuts until they stop.
14. If removed, do the following:
a. Install the air baffle (Installing the air baffle on page 43).
b. Install the processor mezzanine tray (Installing a processor mezzanine tray on page 87).
c. Install the 2P pass-through performance board (Installing a 2P pass-through performance board
on page 88).
15. Install the access panel (Installing the access panel on page 41).
16. Install the server into the rack (Installing the server into the rack on page 34).
17. Connect each power cord to the server.
18. Connect each power cord to the power source.
19. Power up the server (Powering up the server on page 38).
86 Installing hardware options