HP ProLiant DL560 Gen10 User Manual page 78

Prerequisites
Before installing this option, be sure that you have the following:
• T-10 Torx screwdriver
• The components included with the hardware option kit
Procedure
1. Power down the server (Power down the server on page 38).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack (Extend the server from the rack on page 38).
• Remove the server from the rack (Removing the server from the rack on page 39).
4. Remove the access panel (Removing the access panel on page 40).
5. Remove the riser cage (Removing the PCIe riser cages on page 44).
6. Remove the blank from the riser cage.
The primary PCIe riser cage is shown.
7. Install the expansion board into the PCI riser cage.
8. Install the riser cage.
9. Connect any required internal or external cables to the expansion board. See the documentation that
ships with the expansion board.
10. Install the access panel (Installing the access panel on page 41).
11. Install the server into the rack (Installing the server into the rack on page 34).
12. Connect each power cord to the server.
13. Connect each power cord to the power source.
14. Power up the server (Powering up the server on page 38).
78 Installing hardware options