Multicast Filtering Commands; Igmp Snooping; Table 132: Multicast Filtering Commands; Table 133: Igmp Snooping Commands - Digisol DG-FS4526E Management Manual

38
IGMP S
NOOPING
M
ULTICAST
This switch uses IGMP (Internet Group Management Protocol) to check for
any attached hosts that want to receive a specific multicast service. It
identifies the ports containing hosts requesting a service and sends data
out to those ports only. It then propagates the service request up to any
neighboring multicast switch/router to ensure that it will continue to
receive the multicast service.

Table 132: Multicast Filtering Commands

Command Group Function

IGMP Snooping

Configures multicast groups via IGMP snooping or static
assignment, sets the IGMP version, enables proxy reporting,
displays current snooping settings, and displays the multicast
service and group members
Static Multicast Routing Configures static multicast router ports which forward all inbound
multicast traffic to the attached VLANs
IGMP Filtering and Configures IGMP filtering and throttling
Throttling
Multicast VLAN Configures a single network-wide multicast VLAN shared by hosts
Registration residing in other standard or private VLAN groups, preserving
security and data isolation for normal traffic
This section describes commands used to configure IGMP snooping on the
switch.

Table 133: IGMP Snooping Commands

Command Function
ip igmp snooping Enables IGMP snooping
ip igmp snooping priority Assigns a priority to all multicast traffic
ip igmp snooping proxy- Enables IGMP Snooping with Proxy Reporting
reporting
ip igmp snooping querier Allows this device to act as the querier for IGMP
snooping
ip igmp snooping router- Discards any IGMPv2/v3 packets that do not include
alert-option-check the Router Alert option
ip igmp snooping router- Configures the querier timeout
port-expire-time
ip igmp snooping tcn- Floods multicast traffic when a Spanning Tree topology
flood change occurs
ip igmp snooping tcn- Sends an IGMP Query Solicitation when a Spanning
query-solicit Tree topology change occurs
– 961 –
F C
ILTERING OMMANDS
Mode
GC
GC
GC
GC
GC
GC
GC
GC