Ko Propo EX-10 HELIOS Instruction Manual page 26

26
It is the menu displayed when "Enter" is pushed from the initial screen.
Change menu system
Menu addition
The added function name is a list of the
right. however, the one registered in the
menu list is not displayed
It is possible to add it continuously by repeat. Push the
"Back" key when stopping it.(Or, jump to an initial screen
at dash when the "Back" key and "Enter" are pushed at
the same time.)
Main menu (1)
to Menu addition
Add the item to the menu list.
It is possible to add it to CUSTOM1 and CUSTOM2.(It is not
possible to add it to MASTER.)
Menu name selection
Select the added menu name. Move the cursor to either of
CUSTOM1, CUSTOM2 with Jogdial or the the +,- key and
push "Enter".
Function name selectin
The function name that wants to be added and push
"Enter"..
MODEL SELCT
ET:POSITION
SUB:TRIM
ABS
TH:SPEED
TH:PUNCH
TH:CURVE
TH:BRAKE
Additional position
Decide the position where the function selection with Jogdial or
the +, - key is inserted and push "Enter". Insertion is fixed, and
the screen returns to the selection of the function name of two.
The first screen of the main menu becomes a
selection of the change menu system.
Displayed MASTER, CUSTOM1, and CUSTOM2
are name of the menu screen respectively.
It is selected by pushing "Enter" after it moves to
the menu name you want to select the cursor with
Jogdial or the +.- keys, and the display returns to an
initial menu.
The menu is not changed when returning to an initial
screen by pushing the back key.
The menu name does the blinking display if not
registered in each menu at all and it is not possible to
select it.
In the state of the first stage, as for CUSTOM1, only
MODEL.SELECT is registered.
In the state of the first stage, CUSTOM2 is empty.(It
is not possible to select it.)
TH:HIPOINT
TH:PRESET
TH:ACCEL
ST:SPEED
ST:PUNCH
ST:CURVE
ST:BALANCE
ST:TRAVEL
It becomes the order.
(Displayed on the right)
DRAFT
Back Key Back Key
Enter Key Enter Key
JogDial JogDial
+/- Key +/- Key
Reset Reset
Selected CUSTOM1
Selected SUB:TRIM
AUTO:START SET UP
MODEL.COPY UP TIMER
MODEL.NAME DOWN TIMER
MEM.RESET LAP TIMER
ADJUST VR
CH.SELECT
REVERSE
TRIM RATE
SUB:TRIM has
been selected on
this screen. It
tries to insert
SUB:TRIM after
ET:POSITION on
this screen.