Ko Propo EX-10 HELIOS Instruction Manual page 6

F
OR THE SAFE
6
For the safe Usage of this Unit
With the nature of radio controlled models, misoperation will
result in danger. In order to avoid these circumstances and to
use this unit safely, please read the contents thoroughly.
Explanation of warnings and signs
Meanings of
In this manual, following warnings and signs should be noted carefully.
warning
and signs
Meaning of picture indications
Warning
Meaning of picture indications
U
SAGE OF THIS
F a i l u r e t o o b s e r v e t h e m a t t e r d i s c u s s e d i n s u c h a n i t e m p o s e s a s e r i o u s
Danger!
t h r e a t o f d e a t h o r s e v e r e i n j u r y.
F a i l u r e t o o b s e r v e t h e m a t t e r d i s c u s s e d i n s u c h a n i t e m p o s e s a p o s s i b i l i t y
Warning!
o f d e a t h o r s e v e r e i n j u r y, a n d a g r e a t l i k e l i h o o d o f d a m a g e t o t h e e q u i p m e n t
o r p r o p e r t y.
F a i l u r e t o o b s e r v e t h e m a t t e r d i s c u s s e d i n s u c h a n i t e m p o s e s a p o s s i b i l i t y
Caution!
o f i n j u r y o r d a m a g e t o t h e e q u i p m e n t o r p r o p e r t y.
Be certain to use only KO Propo genuine crystal sets (transmitter and receiver).
Warning!
Other crystals may vary in frequency, which could lead to misoperation or loss of
control.
Prevent metal parts in the model ( Car, or Boat ) from touching caused by
Warning!
vibration.
This product is only designed for surface radio control models. Do not use for any
Warning!
other purpose.
If a nicad battery pack is used in the transmitter, be sure to charge
Warning!
properly before use.
If batteries are not fully charged, the model may run out of control.
Be sure to connect all equipments correctly.
Warning!
If connections are loose, the model may run out of control.
The vibration may damage the servo and the model may run out of control
Be sure to install a receiver with thicker double sided tapes.
Warning!
A strong shock or vibration may result in the model running out of control.
Do not cut or bundle the aerial wire with other cords.
Warning!
It may result in decreasing the sensitivity of a receiver and may result in the
model running out of control.
When operating each servo, check that there is no unnecessary force on the push
Warning!
rod.
It may damage the servo or increase the consumption of batteries.
Be sure to use grommets and to prevent the servo from touching any metal or
Warning!
carbon plates directly.
The vibration may damage the servo and the model may run out of control.
DRAFT
U -1
NIT