Ko Propo EX-10 HELIOS Instruction Manual page 13

How to Insert Batteries 2
About Discharging Battery Pack
Please note the battery pack can not be discharged using charging jack.
Please remove battery pack from main unit for discharging.
Color Pad and Replace Grip
How to remove pad or grip.
After it pulls it in the direction of an arrow lower (2), the pad removes
fingernail (1)
After expanding lower side (3) outside, the grip pulls the whole in
direction (4) of the arrow.
How to attach pad or grip.
It does in the reverse order of the removing procedure. The lower side
is done in the slide after the fingernail of (1) is previously encased of
the pad, and it pushes it.
The grip does the whole in the slide and pushes the fingernail on the
side in six places in pushing total into the case. If it is not easy to enter,
it pushes it by a minus driver etc. noting that the case is not damaged.
Finally, push the guide pin that exists in the part of the arrow of (3) into the case.
Changing the RF Module and Crystals
Change the RF Module for changing the frequency range.
Change the crystals for changing the frequency. (band)
Be sure to turn off the switch when you change the RF Module or crystals.
Insert the crystal properly.
When changing the crystals, be sure to use genuine
FM-type transceiver crystals from KO Propo. Crystals
from other manufacturers may operate at slightly different
frequencies, resulting in loss of control.
Only the RF Module for EX-10 Helios can be used.
DRAFT
Pad
Grip
RF Modu
Crystal
13