Honda CB125 Shine SP Owner's Manual page 63

be forced out of the cylinder with subsequent
loss of brake fluid. If this occurs, servicing
of the brake system will be necessary. Visit
your Honda dealer for this service.
Installation Notes:
• Reverse the removal procedure.
• Position the wheel between the fork
legs and insert the front axle from the
right side, through the right fork leg
and wheel hub.
• Tighten the front axle nut to the
specified torque.
Front axle nut torque:
54 N·m (5.5 kgf·m , 40 lbf·ft)
• After installing the wheel, apply the
brake several times and then check if
the wheel rotates freely. Recheck the
wheel if the brake drags or if the wheel
does not rotate freely.
If a torque wrench was not used for
installation, see your Honda dealer as soon
as possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
Honda Motorcycle & Scooter India Pvt. Ltd.
Front Wheel Removal (for Drum brake)
1. Place the vehicle on its center stand.
2. Raise the front wheel off the ground by
placing a support block under the engine.
3. Remove the front brake adjusting nut
(1) and remove the front brake cable
(2) from the brake arm (3).
4. Remove the front axle nut (4).
5. Remove the front axle shaft (5) and the
wheel.
(3)
(4)
(2)
(1)
Brake adjusting nut
(1)
Front brake cable
(2)
Brake arm
(3)
¼cz s d vkeZ ½
(4) Front axle nut ¼Ýa V ,Dly uV½
(5) Front axle shaft
¼Ýa V ,Dly "kkW ¶ V½
(5)
¼cz s d ,MtfLVa x uV½
¼Ýa V cz s d ds c y½
CB125 Shine SP
59