Timer-Functions - VDO Cyclecomputing X3DW Instruction Manual

D GB F I
NAVIGATOR/SELECT
SELECT shows that there is a submenu for the main
NAVIGATOR menu. You open the submenu with
Set
B
You can set a starting value here and decide whether
the counter counts forwards or backwards from

3.2 Timer-Functions

The X3DW has 7 different selectable timers.
Only the timer selected is shown on the display.
STOPWATCH
You can use the stopwatch to measure as ma-
ny times as you want. Maximum value: 23:59:59
HH:MM:SS. If the maximum value is exceeded,
the counter starts again at zero.
Start with M . Stop with
Reset with C for 3 seconds.
TIMER1, TIMER2, TIMER1+2
A time can be entered for TIMER1 and TIMER2.
The timer counts up to the set time, jumps back to
zero and counts again up to the set time.
At the end of TIMER1, 1 beep is heard, at the end of
TIMER2, 2 beeps are heard. TIMER1+2 combines the
two timers, e.g. for interval training.
The number of repeats for TIMER1+2 can be entered
beforehand.Maximum value 23:59:59 HH:MM:SS,
99 repetitions. Start with
Reset with C for 3 seconds.
COUNTDOWN
On the countdown timer, a time can be set.
The timer counts down backwards from this time
to zero. At the end of the countdown a beep is
36 X3DW
M .
. Stop with .
M M
this starting value. Further details in Chapter 5.7.
Reset
B
M . In the reset submenu you set the NAVIGATOR
back to zero. You leave the submenu by pressing
again.
C
heard. Start with
Reset with C
TIME TRIAL
On the TIME TRIAL timer, a distance can be set
(time trial distance). Whilst cycling, the expected
ride time, based on the average speed and the
distance still to be cycled, is constantly shown
alternately on the display.
Start with M . Stop with
Reset with C
LAP TIMER
The lap timer can store 30 laps.
For every lap, the following is saved:
Time
B
Distance
B
Average speed
B
The next lap can be started either manually or
automatically. For the automatic start, a distance
is preset. Once this distance has been cycled, the
next lap is started automatically.
Start the 1 st lap with
Stop with M . Reset with
counter is set to 1. The stored lap data can be
recalled under:
M . Stop with M .
for 3 seconds.
M .
for 3 seconds.
M . Start all other laps with
C for 3 seconds. The lap
VDO CYCLECOMPUTING
C .