The Cooling Phase; Standby Mode; Stove Operation With External Actuation - calimax Solida PR 08 02 01 Operating Instructions Manual

4.4.3. The cooling phase

The screw conveyor is switched off when the cooling phase starts and no wood pel-
lets are conveyed into the burn grate.

4.4.4. Standby mode

Once the set temperature has been reached, the stove switches to the
cooling phase.
When the cooling phase is complete, the standby mode starts. The standby mode
signals that the stove will start heating again automatically when the switch-on tem-
perature is undershot.

4.5. Stove operation with external actuation

The Solida pellet stove offers the pos-
sibility of actuation via an external
thermostat or an external timer. Con-
nection can be implemented on the
rear using the terminal strip next to
the power supply inlet. To connect
the external control system, remove
the cable link (Fig. 6) and connect
the cable of the external control sys-
tem with the RT terminal of the termi-
nal strip.
The external contact must be activated in the control system, simply removing the
cable link is not sufficient.
Activation of the external contact:
Page 14
The pellet stove must be actuated potential-free! Never
apply an input voltage! Only use shielded cables! The
room thermostat may only be connected by a special-
ist!
Press the button.
Scroll to page K17 with the
Activate/deactivate the external contact with the
buttons.
Use the button to leave the customer menu and save the
parameters.
The menu is automatically closed and the parameters
saved after 60 seconds.
Fig. 6: Terminal strip with cable link
button.
or