Transport; Packing; Unpacking; Handling The Machine - Silca Fastbit Operating Manual

Operating manual

2 TRANSPORT

The FASTBIT key-cutting machine is easily transported and is not dangerous to handle.
The packed machine can be carried by one person.

2.1 Packing

The FASTBIT is packed in a strong cardboard box, the dimensions of which are shown in Fig. 8, suffi ciently
robust to be used for storing the machine for long periods.
Inside the box the machine is enclosed in two expanded polymer shells. The shells and cardboard box ensure
safe transportation and protect the machine and all its parts.
NOTE:
to avoid damaging the key-cutting machine it must always be transported in its packing case. This will
prevent sudden movements or rough handling from damaging the machine, persons or things.

2.2 Unpacking

To remove the machine from the packing box:
1) Cut the straps with scissors and remove,
2) Open the box without damaging it as it may be used again (e.g. removals, dispatch to the manufacturers for
repairs or servicing),
3) Check the contents of the box, which should comprise:
1 FASTBIT key-cutting machine packed in a protective shell;
-
1 set of documents, including: operating manual, spare parts list and guarantee;
-
1 carriage handle;
-
1 power cable
-
1 tool set;
-
4) Remove the key-cutting machine from the protective shell.

2.3 Handling the machine

When the FASTBIT has been unpacked, place it directly on its workbench.
This operation can be carried out by one person.
ATTENTION: fi rmly holding the base, and no other part, to lift and carry the machine
Keep dry
Fig. 8
Handle with care
Copyright Silca 2014
This side up
.
FASTBIT
9