Belling 637 Installation And User Instructions Manual page 5

Connecting the
Cooker
Important
Before Cooking
Installing your cooker
WARNING! THIS APPLIANCE MUST BE EARTHED!
Your cooker should have been checked to ensure that the voltage
corresponds with the supply voltage, this is stated on the rating
plate, which is situated adjacent to bottom left hand main oven door
hinge. The cooker must be connected by a qualified electrician to a
suitable double-pole control unit with a minimum of 45A and a
minimum contact clearance of 3mm, which should be fitted adjacent
to (but not above) the cooker, in accordance with current IEE
regulations. The power supply cable should conform to BS6004. We
recommend P.V.C. insulated twin and earth cable with a conductor
size of 6mm 2 . The maximum size of cable that can be used is 10mm
The control unit should be easily accessible in the event of an
emergency.
This appliance conforms to EN55014 regarding suppression of radio
and television interference.
For access to the mains terminal block, for supply cable connection,
it is necessary to remove the mains terminal cover, located at the
lower right-hand side of the rear panel. Pass the cable through the
cable clamp and connect to the appropriate terminals provided.
Tighten the screws on the cable clamp and replace the cover.
No part of the appliance will operate unless the main control unit is
switched O N.
Allow sufficient cable length for the cooker to be pulled out for
cleaning, but do not let it hang closer than 50mm (2") to the floor.
The cable can be looped if necessary, but make sure that it is not
kinked or trapped when the cooker is in position.
Before you cook for the first time, we recommend that you switch
on each element in turn to burn off any odours remaining from
manufacture. Simply operate each hob element and the grill on
maximum for a few minutes, and the oven for approximately 30
minutes. Ensure that the room is well ventilated (eg. open a window
or use an extractor fan) and that persons who may be sensitive to
the odour avoid any fumes. It is suggested that any pets be removed
from the room until the smell has ceased.
Also, before you use the ceramic hob for the first time, clean the
hob surface with Belling Ceramic Hob Cleaner and Conditioner.
This applies a thin protective film to the hob, making it easier to
clean, and prolonging its life.
2 .
5