Belling 637 Installation And User Instructions Manual page 40

CLEANING THE DOOR
Take particular care not to damage the inner surface of the door
inner glass which is coated with a heat reflective layer. Do not use
scouring pads, or abrasive powder, which will scratch the glass.
Ensure that the glass panel is not subjected to any sharp mechanical
blows.
Stubborn stains can be removed by using a fine steel wool pad. For slight
soiling the inner glass panel may be cleaned, while still warm, without removing
it from the door. After cleaning, rinse and dry with a soft cloth.
SIDE OPENING DOORS
Cleaning the door glass is the same as the drop down doors, except
take care to support the weight of the inner glass when removing
and refitting.
DROP DOWN DOORS
Remove the door inner glass as follows.
1 . Open the door fully and unscrew the two screws securing the glass
panel so that the securing brackets can be turned.
There is no need to remove the screws completely.
2 . Turn the brackets so that the glass can be
removed and cleaned at the sink (Fig. 1.)
3 . The inside of the outer door glass
can now be cleaned while still fitted
to the cooker.
NEVER OPERATE THE COOKER WITHOUT THE INNER DOOR GLASS IN
POSITION.
Refit the door inner glass as follows.
1 . NOTE: The inner door glass has a special reflective coating on one side.
Replace the door inner glass so that the
statement:
"IMPORTANT THIS FACE TOWARDS
THE OVEN" can be read from the inner
side of the door.
2 . Turn the two securing brackets back to
their original position to retain
the glass and tighten the screws. (Fig. 2.)
40
Care and Cleaning
Fig. 1.
Glass
Glass
Fig. 2.