Specifying The Pim Vrf Instance - Cisco XR12000 Series Configuration Manual

Implementing Multicast Routing on Cisco IOS XR Software
Command or Action
Step 13
interface all enable
Example:
RP/0/0/CPU0:router(config-mcast-default-ipv4)#
interface all enable
Step 14 Use the commit or end command.

Specifying the PIM VRF Instance

If you are configuring Protocol Independent Multicast in sparse mode (PIM-SM) in the MVPN, you may also
need to configure a rendezvous point (RP). This task specifies the optional PIM VPN instance.
SUMMARY STEPS
1. configure
2. router pim vrf vrf-name address-family {ipv4 | ipv6}
3. rp-address ip-address [group-access-list-name] override]
4. Use the commit or end command.
OL-30405-02
Purpose
You may also, optionally, configure an access list to limit the
number of groups to be tunneled through a data MDT group.
Traffic from groups not on the access-list continues to be
tunneled using the default MDT group.
Enables multicast routing and forwarding on all new and existing
interfaces.
commit—Saves the configuration changes, and remains within
the configuration session.
end—Prompts user to take one of these actions:
Cisco IOS XR Multicast Configuration Guide for the Cisco XR12000 Series Router, Release 5.1.x
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
Configuring Multicast VPN
63