Calculating Rates Per Route - Cisco XR12000 Series Configuration Manual

Calculating Rates per Route

Calculating Rates per Route
This procedure enables multicast hardware forward-rate counters on a per-VRF-family basis.
SUMMARY STEPS
1. configure
2. multicast-routing [vrf vrf-name] [address-family {ipv4 | ipv6}]
3. rate-per-route
4. interface {type interface-path-id | all} enable
5. Do one of the following:
6. Use the commit or end command.
7. show mfib [vrf vrf-name] [ipv4 | ipv6] route [rate | statistics] [* | source-address] [group-address
[/prefix-length] [detail | old-output] | summary] [location node-id]
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/0/CPU0:router# configure
Step 2
multicast-routing [vrf vrf-name] [address-family
{ipv4 | ipv6}]
Example:
RP/0/0/CPU0:router(config)# multicast-routing
address-family ipv4
Step 3 rate-per-route
Example:
RP/0/0/CPU0:router(config-mcast-default-ipv4)#
rate-per-route
Cisco IOS XR Multicast Configuration Guide for the Cisco XR12000 Series Router, Release 5.1.x
54
• accounting per-prefix
• accounting per-prefix forward-only
Implementing Multicast Routing on Cisco IOS XR Software
Purpose
Enters global configuration mode.
Enters multicast routing configuration mode.
• The following multicast processes are started: MRIB,
MFWD, PIM, IGMP, and MLD.
• For IPv4, IGMP version 3 is enabled by default; for IPv6,
MLD version 1 is enabled by default.
Enables a per (S,G) rate calculation for a particular route.
OL-30405-02