Next-Generation Multicast Vpn - Cisco XR12000 Series Configuration Manual

Next-Generation Multicast VPN

• Configuring BGP vpnv4 address family
• Configuring BGP IPv4 VRF address family
• Configuring PIM SM/SSM Mode for the VRFs
• Configuring route-policy
The configuration of the above procedures depends on the profile used for each configuration. For detailed
Note
examples of each profile, see
Next-Generation Multicast VPN
Next-Generation Multicast VPN (NG-MVPN) offers more scalability for Layer 3 VPN multicast traffic. It
allows point-to-multipoint Label Switched Paths (LSP) to be used to transport the multicast traffic between
PEs, thus allowing the multicast traffic and the unicast traffic to benefit from the advantages of MPLS transport,
Cisco IOS XR Multicast Configuration Guide for the Cisco XR12000 Series Router, Release 5.1.x
38
◦ address-family ipv4 mdt
◦ configure
◦ router bgp AS Number
◦ address-family vpnv4 unicast
◦ configure
◦ router bgp AS Number
◦ vrf vrf_name
◦ address-family ipv4 unicast
◦ configure
◦ router pim
◦ vrf vrf_name
◦ address-family ipv4
◦ rpf topology route-policy rosen_mvpn_mldp
For each profile, a different route-policy is configured.
◦ route-policy rosen_mvpn_mldp
◦ set core-tree tree-type
◦ pass
◦ end-policy
For profile 1 (MLDP Rosen), the mldp-rosen core tree type and for profile 4/5 (MS- PMSI with BGP-AD),
the mldp-partitioned-mp2mp/p2mp core tree type are configured.
Configuring LSM based MLDP: Examples, on page
Implementing Multicast Routing on Cisco IOS XR Software
150.
OL-30405-02