Viavi HST-3000 Manual

Ethernet layer 3 traffic testing

Hide thumbs Also See for HST-3000:

HST-3000 Ethernet Layer 3 Traffic

following procedure outlines how to configure the HST-3000 utilizing the Electrical (RJ-

45) Ethernet Interface to conduct a bit error rate test. Please read entire procedure

BEFORE starting.

Menu selections are made from the HST-3000 front panel either by using the keypad to

select the option number OR by using the arrow keys to scroll to the desired selection and

pressing the OK key.

Please note that this same procedure may be used for Optical (MMF, SMF) Ethernet

Interface, substituting appropriate Fiber Optic Connectors and selecting the ETH

OPTIC soft key in Part 1, Step 2.

HST-3000 Front Panel:

Status LEDs

LCD

Readable in

direct sunlight

Arrow keys

Cancel Key

Keypad

12 Buttons

Power Key

Testing

Page 1 of 5

The

Soft Keys

4 Keys

Microphone

OK Key

Navigation Keys

4 Keys

Second function key

Table of Contents

Need help?

Do you have a question about the HST-3000 and is the answer not in the manual?

Page 1 45) Ethernet Interface to conduct a bit error rate test. Please read entire procedure BEFORE starting. Menu selections are made from the HST-3000 front panel either by using the keypad to select the option number OR by using the arrow keys to scroll to the desired selection and pressing the OK key.
Page 2 Page 2 of 5 Part 1: Configuring the HST-3000 Step Action Details Power Press the green Power Key to turn on the HST. ETH ELEC Press the ETH ELEC Soft key to test 10/100/1000 Mbps Ethernet via the SIM RJ-45 interface.
Page 3 Home Press the HOME Navigation Key to return to the Results Screen. Connect the HST-3000 to the line under test using the Electical RJ-45 connector labels R/T 1 on the left side of the SIM. Part 3: Verifying Connectivity Step...
Page 4 Press the Restart soft key to reset counter and alarms. ALL SUMMARY RESULTS OK should be displayed. Test Allow HST-3000 to perform test for desired amount of time. Display Press the Display soft key to select Results views. Verify that test results in Link Stats and Error Stats meet requirements for the line under test.
Page 5 Page 5 of 5 Display Press the Display soft key to select additional Results views, if required to troubleshoot the line under test: Save Press the Results soft key and select Save to save test results. Action Press the Action soft key and select 1-Stop Traffic.