Polycom Viewstation 128 User Manual page 124

Troubleshooting
Symptom
Near-site or far-site can
not hear or see the VCR
audio.
Video
Picture is blank on the
main monitor.
Same picture is seen on
first and second monitor.
Picture freezes often
during a call.
Picture slow or jerky.
Camera voice tracking
does not work.
Blue screen in the PIP
window.
Near end camera does
not pan or tilt.
124
Cause
VCR input is not selected.
System goes to 'sleep' mode
after 10 minutes of inactivity.
Monitors are connected to the
same output. Monitor has a
composite as well as an S-
Video output.
ISDN line transmission errors.
Check the error count under
the Diagnostics menu.
Only one 64K channel is
connecting in your call.
Lots of motion in the picture
you are receiving.
Camera tracking was turned
off by near or far-site.
The far-site is speaking.
The far-site is very noisy.
Near-site is on mute.
Near-site is noisy or too many
people talking at once.
No video input.
The VCR input is selected and
the VCR is idle or not running.
Most VCRs generate a blue
screen when the tape is not
playing.
You are attempting to move
Camera 2 or 3.
Solution
Turn on the VCR input by selecting the NEAR
key twice and selecting the VCR icon.
Pick up the remote control. System will wake
up.
Connect Monitor 2 to the Monitor 2
connection on the rear panel of the
ViewStation.
Check your system by doing a local
loopback under the Diagnostics menu. If the
picture does not freeze, perform the same
test at the far-site system. Perform a far-site
loopback during a call. If the picture freezes
there are line errors on your ISDN lines.
You can also test this by placing a video call
to an ISDN loopback number provided by
your service provider.
Check the ISDN number of the far-site. Ask
the far-site to call your site.
A background with less motion will provide
a better, smoother video picture.
Camera tracking is turned off when the near
or far-site move your camera. Press the
AUTO button to restore tracking.
The camera stops tracking when the far-site
speaks to prevent the camera from pointing
to your monitor speaker.
The camera stops tracking when the far-site
has a loud noise.
The near-site camera does not track when
the near-site is on 'MUTE.' Toggle mute
function with the MUTE button.
Reduce the noise in the room.
Check that there is a video source present on
the selected input.
Select a different input on the ViewStation or
play a tape on the VCR.
Camera 1 is the only movable camera.
ViewStation User's Guide