Table of Contents
Advertisement
Packing a SIP for Shipment
•
Two foam packing cushions
Use Cisco Systems original packaging for the shipment of all SIPs. Failure to properly use Cisco
Caution
Systems packaging can result in damage or loss of product.
Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself.
These instructions assume that the SIP has been removed from the router according to the recommended
Note
procedures specified in this guide.
To pack a SIP for shipment, follow these steps:
Insert the SIP into the static shielding bag.
Step 1
Step 2
Insert the bagged SIP into the smaller inner carton. Be careful to position the SIP so that the faceplate is
up against the cardboard cushions. Fold the small flaps first and then the big flaps.
Close the smaller inner carton and tape the sides closed.
Step 3
Place the sealed smaller inner carton containing the SIP into the two foam packing cushions (they only
Step 4
fit one way).
Place the sealed smaller inner carton and packing cushions into the larger exterior carton, and seal the
Step 5
larger exterior carton with tape for shipment.
Cisco 10000 Series Router SIP and SPA Hardware Installation Guide
7-66
Chapter 7
Troubleshooting the Installation
OL-13838-02
Advertisement
Table of Contents
