Table of Contents
Advertisement
Preparing to Install a SIP or a SPA
This chapter describes the general equipment, safety, and site preparation requirements for installing
SIPs and SPAs. This chapter contains the following sections:
•
•
•
Required Tools and Equipment
You need the following tools and parts to install SIPs and SPAs. If you need additional equipment,
contact a service representative for ordering information.
•
•
•
•
•
•
•
Safety Guidelines
This section provides safety guidelines that you should follow when working with any equipment that
connects to electrical power or telephone wiring.
Safety Warnings
Safety warnings appear throughout this publication in procedures that, if performed incorrectly, might
harm you. A warning symbol precedes each warning statement.
OL-13838-02
Required Tools and Equipment, page 4-35
Safety Guidelines, page 4-35
Laser/LED Safety, page 4-41
Shared port adapter interface processor (SIP)
Shared port adapter (SPA)
Number 1 Phillips and a 3/16-inch flat-blade screwdriver
Number 2 Phillips screwdriver
Your own electrostatic discharge (ESD)-prevention equipment or the disposable grounding wrist
strap supplied with the SIP or SPA
Antistatic mat
Antistatic container
C H A P T E R
Cisco 10000 Series Router SIP and SPA Hardware Installation Guide
4
4-35
Advertisement
Table of Contents
