Safety And Compliance; Part 15 Rules; Class B Digital Device Or Peripheral - Polycom SoundPoint IP 430 SIP User Manual

No Response from Feature Key Presses
Verify phone is in active state:
• Make a call to the phone to check
for inbound call display and ring-
ing as normal. If successful, try to
press feature keys within the call to
access Directory or Buddy Status for
example.
Display shows "Network Link is Down"
Verify LAN cable is properly connected:
Directories
• Check termination at the switch or
Services
hub (furthest end of the cable from
the phone).
Conference
• Check that the switch or hub is opera-
Transfer
tional (flashing link/status lights) or
Redial
contact your System Administrator.

Safety and Compliance

Part 15 Rules

This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful
interference, and

Class B Digital Device or Peripheral

Note: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harm-
ful interference in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interfer-
ence to radio communications. However,
there is no guarantee that interference will
not occur in a particular installation. If this
equipment does cause harmful interference
VoIPon www.voipon.co.uk
1
1
4
GHI
4
GHI
7
PQRS
7
PQRS
Hold
*
sales@voipon.co.uk
• Press
Network and Ethernet. Scroll down
to verify LAN port is Active.
2 3
ABC DEF
2 3
• Reboot the phone to attempt recon-
ABC DEF
nection to the network.
5 6
JKL MNO
5 6
JKL MNO
8 9
TUV WXYZ
8 9
TUV WXYZ
0
OPER
#
0
OPER
2. This device must accept any interfer-
ences received, including interference
that may cause undesired operation.
to radio or television reception, which
can be determined by turning the equip-
ment off and on, the user is encouraged
to try to correct the interference by one
or more of the following measures:
1. Reorient or relocate the receiving
antenna.
2. Increase the separation between the
equipment and receiver.
3. Connect the equipment into an out-
let on a circuit different from that
to which the receiver is connected.
4. Consult the dealer or an experience
radio/TV technician for help.
23
Tel: +44 (0)1245 808195
Del
followed by Status,
Menu
Messages
Do Not Disturb
Hold
Fax: +44 (0)1245 600030