All manuals and user guides at all-guides.com
No Response from Feature Key Presses
Verify phone is in active state:
• Make a call to the phone to check
Directories
for inbound call display and ring-
Services
ing as normal. If successful, try to
press feature keys within the call to
Conference
access Directory or Buddy Status for
Transfer
example.
Redial
Hold
Display shows "Network Link is Down"
Verify LAN cable is properly connected:
• Check termination at the switch or
Directories
hub (furthest end of the cable from
Services
the phone).
• Check that the switch or hub is opera-
Conference
tional (flashing link/status lights) or
Transfer
contact your System Administrator.
Redial
Hold
Safety and Compliance
Part 15 Rules
This device complies with Part 15 of the
FCC Rules. Operation is subject to the fol-
lowing two conditions:
1. This device may not cause harmful
interference, and
Class B Digital Device or Peripheral
Note: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harm-
ful interference in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interfer-
ence to radio communications. However,
there is no guarantee that interference will
not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can
be determined by turning the equipment off
• Press
Status and Server Status to confirm
line is actively registered to the
1
ABC
2
3
DEF
1
2
3
server.
ABC
DEF
• Reboot the phone to attempt re-reg-
4
5
6
GHI
JKL
MNO
4
5
6
istration to the server.
GHI
JKL
MNO
7
8
9
PQRS
TUV
WXYZ
7
8
9
PQRS
TUV
WXYZ
0
OPER
*
#
0
OPER
• Press
Status and Network Status. Scroll
down to verify LAN port is Active.
1
ABC
2
3
DEF
1
2
3
• Reboot the phone to attempt recon-
ABC
DEF
nection to the network.
4
5
6
GHI
JKL
MNO
4
5
6
GHI
JKL
MNO
7
8
9
PQRS
TUV
WXYZ
7
8
9
PQRS
TUV
WXYZ
0
OPER
*
#
0
OPER
2. This device must accept any
interferences received, including in-
terference that may cause undesired
operation.
and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
1. Reorient or relocate the receiving
2. Increase the separation between the
3. Connect the equipment into an out-
4. Consult the dealer or an experience
21
Sel
Del
followed by System
Menu
Messages
Do Not Disturb
Hold
Sel
Del
followed by System
Menu
Messages
Do Not Disturb
Hold
antenna.
equipment and receiver.
let on a circuit different from that
to which the receiver is connected.
radio/TV technician for help.
Need help?
Do you have a question about the SoundPoint IP 600 SIP and is the answer not in the manual?