Replacing the status-light board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.
Procedure
1
Place the status-light board into the slot on the palm-rest assembly.
2
Adhere the foam that secures the status-light board to the palm-rest assembly.
3
Slide the status-light board cable into the connector on the system board and
close the latch to secure the cable.
4
Route the speaker cable through the routing guides on the palm-rest assembly.
Post-requisites
1
Replace the battery.
2
Replace the
base
computer. After working inside your computer, follow
After working inside your
cover.
computer. For more safety best
www.dell.com/
Before
49