Figure 1-6 Pdu Bus Bar Cover; Cable Routing; Customer Access Panel - Cisco ONS 15600 Reference Manual

Chapter 1 Shelf and Backplane Hardware
Figure 1-6

1.5 Cable Routing

The narrow and wide cable routing modules (CRMs) can be installed on the sides of the bay to manage
and contain the optical cables as they are routed away from the bay. You can use both types of fiber
routing systems with overhead or under-floor cabling.

1.6 Customer Access Panel

The Customer Access Panel (CAP) is located in the middle of the rear of the shelf. The CAP provides
an alarm pin field, timing, and LAN connections. The CAP plugs into the backplane using 2mm Hard
Metric connectors with 752 pins and is held in place with one large captive bolt and multiple screws.
Figure 1-7
Only T1 (100 ohm) building integrated timing supply (BITS) is supported in Software R6.0.
Note
PDU Bus Bar Cover
shows the location of the CAP on the back of the shelf.
Cisco ONS 15600 Reference Manual, R6.0
1.5 Cable Routing
1-7