Hangar 9 Piper Pawnee 40 ARF Assembly Manual page 12

Section 1: Landing Gear and Rudder Installation

Step 9
Attach the landing gear to the fuselage using four landing
gear straps and eight 3mm x 10mm sheet metal screws
and a #2 Phillips screwdriver.

Step 10
Use sandpaper to roughen the wire so the epoxy will have
a rough surface to bond to.
12
www.modellmarkt24.ch www.modellmarkt24.ch

Step 11
Apply a small amount of petroleum jelly to the top and
bottom of the tail gear bushing. Work the jelly into the
bushing to prevent epoxy from entering the bushing and
locking the tail gear wire.

Step 12
Use 30-minute epoxy to glue the tail gear bushing into
the fuselage. Make sure the bushing is pressed tight in
the fuselage, and has been slid down toward the bottom
of the fuselage as far as possible.