Table of Contents
Advertisement
o
Step 5
Slide the outer wheel hub back into the wheel. Slide the
supplied hex wrench into the screw hole in the outer
wheel hub, then into the screw hole in the inner wheel hub
to aid in aligning the screw holes.
www.modellmarkt24.ch
www.modellmarkt24.ch
Section 1: Landing Gear and Rudder Installation
o
Step 6
Reinstall the four sheet metal screws to secure the inner
and outer wheel hubs in the wheel.
o
Step 7
Snap the cap back in position on the outer wheel hub.
Step 8
Repeat Steps 1 through 7 to install the remaining wheel
onto the landing gear.
11
Hide quick links:
Advertisement
Table of Contents
