3 Printer Operation
3.2.2 Dump Mode
The printer will enter the Dump mode after running a self test. In this mode,
characters are printed in hexadecimal codes, allowing users and engineers to
debug the system.
To return to the online mode:
■
Turn off the printer, and turn it on again.
3.3 Resetting Your Printer
By resetting your printer, you can return your printer to the state it was in
when you receive it. This can help you solve some problems caused by
settings changed during the printing.
Do the following to reset your printer:
1. Turn off the printer.
2. Press and hold the FEED button, and turn on the printer.
3. Both status lights glow solid orange for a few seconds. Next, they turn to
green shortly, and then turn to other colors. When both lights turn to
red, release the FEED button immediately.
4. Press and hold the FEED button for 3 seconds and release it. Both status
lights blink red three times, and turn to solid orange for a few seconds.
After the printer is reset, LED 2 goes out while LED 1 turns to solid green.
Important In step 4, if you do not hold the FEED button long enough,
LED 2 will blink orange three times while LED 1 goes out. It means the
printer is not reset.
20
Resetting Your Printer