Troubleshooting - Electrolux EOB5450AAX User Manual

8. Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
9. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, install
the glass panels and the door. Do the
above steps in the opposite sequence.
Install the smaller panel first, then the
larger.
10.5 Replacing the lamp
Put a cloth on the bottom of the interior
of the appliance. It prevents damage to
the lamp glass cover and the cavity.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.

11. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
11.1 What to do if...
Problem
You cannot activate or op‐
erate the oven. The display
shows "400" and an acous‐
tic signal sounds.
The oven does not heat
up.
The oven does not heat
up.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box
The top lamp
1. Turn the lamp glass cover
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
4. Install the glass cover.
Possible cause
The oven is incorrectly
connected to an electrical
supply.
The oven is deactivated.
The clock is not set.
or deactivate the circuit breaker.
counterclockwise to remove it.
°C heat-resistant lamp.
Remedy
Check if the oven is cor‐
rectly connected to the
electrical supply (refer to
the connection diagram if
available).
Activate the oven.
Set the clock.
ENGLISH 27