Table of Contents
Advertisement
12.7 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the oven. Wait until the oven is
cold.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
CAUTION!
Always hold the halogen lamp with a
cloth to prevent grease residue from
burning on the lamp.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem
You cannot activate or operate the appliance.
The appliance does not heat up.
The appliance does not heat up.
The appliance does not heat up.
The appliance does not heat up.
The lamp is turned off.
The lamp does not work.
The Food sensor does not operate.
Err C2
Err C3
Err F102
Err F102
00:00
The water leaks out of the cavity embossment.
24
ENGLISH
Back lamp
1. Turn the glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
4. Install the glass cover.
Check if...
The appliance is correctly connected to an electrical
supply.
The automatic switch-off is deactivated.
The appliance door is closed.
The fuse is not blown.
Lock is deactivated.
Moist Fan Baking - is activated.
The lamp is burnt out.
The plug of the Food sensor is fully inserted into the
socket.
You removed the Food sensor plug from the socket.
The appliance door is closed or the door lock is not bro‐
ken.
The appliance door is closed.
The door lock is not broken.
There was a power cut. Set the time of day.
There is too much water in the cavity embossment.
Advertisement
Table of Contents
