Working Instructions - Fein KBM32Q Instruction Manual

3 41 01 011 21 0.book Seite 13 Montag, 8. Februar 2010 11:51 11

Working instructions.

Secure the power tool with the clamping strap supplied if there is danger of it fal-
WARNING
ling, especially for work carried out at a height, on vertical construction elements
or above the head. If there is a power cut, or the mains plug is pulled out, the magnetic holding
power is not maintained.
For switching the magnet ON (Figure 6).
Please make sure that the contacting sur-
face for the magnetic foot is level, clean
and rust-free. Remove any varnish or primer.
When working, always use the magnetic
foot; pay attention that the magnetic hol-
ding power is sufficient.
When working on materials that are not mag-
netizable, suitable fixation devices, obtainable
as accessories from FEIN, e. g. suction plate,
vacuum plate or pipe-drilling device must be
used.
When work on steel materials with a material
thickness of less than 12 mm, the workpiece
must be reinforced with an additional steel
plate in order to guarantee the magnetic hol-
ding power.
The magnetic foot is monitored by means of
a power sensor. If the magnetic foot is defec-
tive, the motor will not start.
Press the main switch to start the
machine.
Adjusting the stroke range (Figure 7).
For quick and easy tool changing, the stroke
range can be variably adjusted.
Hold the drill motor firmly
CAUTION
with one hand when releasing
the fastening lever.
Release both fastening levers with the
other hand.
Adjust the requested stroke range.
Tighten clamping levers again.
Fig. 6
Fig. 7
Fastening
lever
en
13
Main
switch